Bending bench for vise mounting - standard professional - 450 mm working width - sheets up to 1.2 mm
| € 210,00 |
| Price incl. VAT |
Delivery within 7-10 days
Do you have any questions?
We would like to assist you!
We would like to assist you!
Item No.:
946145012000
Product Description
- The mobile bending bench Standard-Profi is suitable for universal use in schools, on construction sites and in workshops.
- Also for the hobbyist, semi professional and professional for occasional use.
- The folding bench has a working width of 450 mm and can be used for sheets of up to 1.2 mm (Tip: For thicker sheets or permanent bending, support the upper beam with a screw clamp so that it remains flat).
- The upper cheek is pushed open by a strong spring, bending cheek shows in the unloaded state vertically downwards (The bending cheek can with the reinforcement to the outside or inside show, then this also depends vertically downwards If the bending cheek with the reinforcement after attaches inside, then this does not disturb the front edges).
- Edges up to approx. 135 ° possible.
- The rear tab is for vise mounting (120x22 mm), sturdy screws at the back for adjusting and counteracting larger curves (when bending up the sheet is pressed against these screws).
- The handles are front equipped with plastic coating for a better grip.
- Note - The bending cheek points with the reinforcement to the outside, then this also depends vertically downwards. If you attach the bending beam the other way around, then the reinforcement does not disturb the front, but the cheek does not hang down vertically (about 100 °) and the bending radius increases as the gap grows larger downwards.
- Working width - 450 mm
- Sheet thickness - 1.2 mm
- Length handles - 380 mm
Bending angle reader and bending angle limiter available on request
Ratings
No evaluation has been given
